Open up the “Config PPP” Control
Panel. It can be found in your “Control Panels” folder.
For “Port Name:” select “Modem
Port”.
Set “Idle Timeout” to “None”.
Set the “Echo Interval (seconds)”
to “Off”.
Click on “Hangup on Close”. None
of the Other boxes need to have an “X” in them.
Click on the “Config…”
button.
Change the “PPP Server Name” to
“Cyberonic”.
Set the “Port Speed:” to the speed
just faster than your modem speed.
For “Flow Control:” choose
“CTS Only”.
For “Phone num” put the number you
dial to connect to Cyberonic.
For the “Modem Init” you’ll
need to find a Modem Init that will work for your modem. You can find the right Init in
your modem’s manual. With most modems, you can use “AT&F&C1&D0”
(that’s a zero follows the &D). If you have a Global Village or Supra external
modem, try “AT&F1”. If none of these gets you connected, call Cyberonic
Technical Support at (888)929-2372 or email us at info@cyberonic.com
.
Change the “Modem connect timeout:”
to “90 seconds”.
Click on the “Connect Script…”
button. You'll get a window with 8 rows of boxes.
You don’t need a script to connect to Cyberonic,
so if there’s anything in the large boxes, delete it. Make all 8 rows blank. Make
sure the “CR” boxes are blank.
Click the “OK” button.
Click the “Authentication…”
button.
Type in your Login ID (Your Login ID will be 3
letters, followed by a number, followed by @cyberonic. For example
"aaa1@cyberonic". Keep in mind it is not @cyberonic.com.)
Type in your password. Note: This is optional. If you
don’t type in your password, it will prompt you for a password when you try to
connect.
Click the “OK” button.
Click the “Done” button.
Close the “Config PPP” Control
Panel and restart your Mac.
|